Vertical saber stand V3 [Digital file]

This is a set of 3D files to print at home of the Laredo Sabers vertical base V3. 

Printing recommendations:

1. Print it upright with supports only on the curved section at the bottom (from the outside), as some printers don't handle that little curve well.
2. I recommend a minimum of 25% fill to give it a good weight.
3. PLA or PETG work well.
4. Maximum layer height of 0.2 mm.
5. Minimum of 3 walls, 3 floors and 3 ceilings.

NOTE: When purchasing these files you are accepting that they are for personal use only. You are not authorized to sell 3d prints of these files.